Still time, handmade embossed mobile phone protective case

The mobile phone protective case made of flowers is simple and suitable for the elegant you. In fact, their production is also very simple. Today I will teach you how to make them.

Other things you’ll need are: white iPhone case, craft glue, work tablet, tape scissors, wax paper, ruler, small marker, timer, 2 clean plastic cups, two craft sticks with acetone Nail polish remover, cotton swabs, transparent resin


The first step is to design your dried flowers. Arrange the dried flowers on the phone case in any combination and shape you like. Be careful not to spread it too thickly. Just one layer of flowers is enough. Place the light-colored flowers underneath the darker ones, because the flowers will become transparent after the resin is applied. some.


Place the ruler into a clean plastic cup and mark the 3/8-inch and 3/4-inch marks with a marker. Set a timer for 2 minutes and have a craft stick ready to use as a stirring stick. Slowly pour the resin into the cup at the 3/8 mark, remember to be accurate. Then pour the curing agent into the 3/4 mark, and be sure not to exceed the mark. At this time, start the timer and continue stirring for 2 minutes with the stirring stick. When the 2 minutes are up, have another cup and another stirring stick ready at hand. Wait for another minute and pour the stirred mixture into the empty cup you just prepared. Stir while pouring until one minute is up, then set it aside for 5 minutes.

The third step is to apply the resin on the mobile phone case. Slowly add a little bit of resin to the center of the mobile phone case with a stirring stick. Be sure to add it little by little. Use a stir stick to spread the resin evenly to the edge of the phone case. Do not let the resin run outside the edge. Then add a little more resin so that all the dried flowers and all the phone cases are coated with resin. Blow gently on the surface to dislodge any air bubbles.

Place the phone case on wax paper and let it dry for 1-2 hours. Use a cotton swab dipped in acetone-containing nail polish remover to wipe the resin from the edge of the phone case. When the first layer of resin is dry, check to see if all the dried flowers are covered. If some are not covered, you can apply the second layer of resin according to the previous steps.

You’re done~ Now you have a beautiful and special phone case that adds fresh and interesting content to your conversations with your friends.